2023 Updated Verified Pass 300-510 Study Guides & Best Courses
Ultimate Guide to the 300-510 - Latest Edition Available Now
What is the duration, language, and format of Implementing Cisco Service Provider Advanced Routing Solutions (300-510 SPRI) Exam
- Duration of Exam: 90 minutes
- Validity: 3 years
- Format: Multiple choice
- Language of Exam: English
Implementing Cisco Service Provider Advanced Routing Solutions (300-510 SPRI) Certification Path
Implementing Cisco Service Provider Advanced Routing Solutions (300-510 SPRI) exam is affiliated with the CCNP Service Provider and Cisco Accredited Professional-Service Provider VPN Services Implementation certifications. This is the official prerequisite for this exam. However, the course, Integrating VPN Services from Cisco Service Provider, allows applicants to prepare for this exam and is highly recommended.
NEW QUESTION 12
Refer to the exhibit.
Refer to the exhibit. After a recent network implementation project, customer A is performing stress testing to verify network redundancy at the branch office connected to R4. When the link from R2 is shut Oown as shown, the SLA tracking object fails and the cost of the link between R2 and R4 increases to 100. However, a traceroute operation from a PC in the Branch office shows that traffic to HQ is still routed via R2. Which solution corrects the problem and optimizes traffic flow via R3 without creating operational overhead?
- A. Configure two OSPF processes on R2 and R3 and redistribute traffic between them.
- B. Use multiarea adjacency to extend Area 10 to the link between R2 and R3.
- C. Create a virtual channel from R3 to R4.
- D. Redistribute routes from BGP to OSPF as type El.
Answer: D
NEW QUESTION 13
A network engineer is troubleshooting OSPF multiarea. Which Cisco IOS XR feature should the engineer use in order to streamline OSPF issue?
- A. routing process enabled by default on all interfaces
- B. hierarchical CLI
- C. DR support for topology management
- D. show lp ospf topology command
Answer: D
NEW QUESTION 14
Refer to the exhibit
Router R1 is configured to advertise outgoing SA messages to routers R2 and R3, but to receive incoming SA messages only from R2. Which additional configuration must an engineer apply to router R1 so it filters all MSDP SA messages from Domain-C?
- A. R3# ip msdp sa-filter out 192.168.3.1
- B. R3# ip msdp password peer 192.168.1.1
- C. R1# ip msdp password peer 192.168.3.1
- D. R1# ip msdp sa-filter in 192.168.3.1
Answer: D
NEW QUESTION 15
You have configured MSDP peering between two autonomous systems that pass traffic between two sites, but the peering has failed to come up.
Which task do you perform to begin troubleshooting the problem?
- A. Verify that multicast has been disabled globally
- B. Verify that both source interfaces are reachable from both peers
- C. Verify that PIM-DM is configured on the source interface
- D. Verify that the two MSDP peers allow asymmetric routing
Answer: B
NEW QUESTION 16 
Refer to the exhibit. A network operator wants to expand the segment routing global block in upcoming maintenance. The operator must ensure that the changes to the segment routing global block have no adverse impacts on the prefix-sid associated with the loopback0 interface used within the OSPF domain. Which command can the operator use to enforce R2 to have a strict prefix-sid assignment to loopback0?
- A.
- B.
- C.
- D.
Answer: D
NEW QUESTION 17
Drag and Drop Question
Drag and drop the attributes for the BGP route selection on the left into the correct order on the right. Not all options are used.
Answer:
Explanation:
Explanation:
https://www.cisco.com/c/en/us/support/docs/ip/border-gateway-protocol-bgp/13753-25.html
NEW QUESTION 18
What are two differences between OSPF and IS-IS? (Choose two.)
- A. Unlike OSPF. IS-IS supports virtual links.
- B. Unlike IS-IS routers, an OSPF router belongs to only one area in addition to the backbone area.
- C. OSPF elects a DR and a BDR, and IS-IS elects a DIS.
- D. OSPF is a link-state routing protocol, and IS-IS is a distance-vector routing protocol.
- E. OSPF uses a router ID to identify a router, and IS-IS uses a system ID.
Answer: C,E
NEW QUESTION 19
Refer to the exhibit.
The green policy is designed with low delay, and the pink policy is designed with low cost. What is the next hop for node A on its way to node D, with the objective of achieving a low delay?
- A. 192.168.1.6
- B. 192.168.3.2
- C. 192. 168.1.2
- D. 192.168.3.6
Answer: C
NEW QUESTION 20
Refer to the exhibit.
XR1 and XR2 are sending the prefix 10.11.11.0/24 to XR3. A configured policy on XR1 is incorrectly prepending AS path 11 11 12 12 onto this prefix. A network operator wants to add a policy onto XR3 that will not allow the falsely prepending prefix from being installed. Which policy configuration applied to the XR3 neighbor configuration for XR1 can accomplish this requirement without impact to other or future received routes?
- A. Option C
- B. Option D
- C. Option B
- D. Option A
Answer: B
Explanation:
Reference:
b_routing_cr41crs/b_routing_cr41crs_chapter_01000.html#wp3850885229
NEW QUESTION 21
Refer to the exhibit.
Refer to the exhibit Networks 172.16.31.0/24 and 172 16 30.0/24 are advertised in area 34. and network 172.22 10.0/24 is advertised in area 0. A recent security review discovered that users connected to routers R1 and R2 have been making unauthorized access to an application running on network 172 16 31 0/24 An engineer determined that routers R1 and R2 are receiving updates for network 17 16 31 0/24 Which action resolves the issue?
- A. Apply route filtering on routers R3 and R4.
- B. Apply route filtering on router R4 only.
- C. Apply route filtering on router R3 only.
- D. Apply route filtering on routers RI and R2
Answer: B
NEW QUESTION 22
Which two differences should be considered when deciding whether to implement to implement routing policies or route maps? (Choose two.)
- A. Route maps are supported in Cisco 10S Software and routing policies are supported in Cisco IOS XR Software.
- B. Route maps require an explicit deny at the end of the sequence, but routing policies have an implicit deny at the end of the program.
- C. Route policies require sequence numbers, but route maps are implemented without sequencing.
- D. Route maps are implemented using hierarchical policies, but routing policies must be implemented sequentially.
- E. Sequences are added after implementing a route map, but routing policies must be reconfigured when change is needed.
Answer: A,E
NEW QUESTION 23
Refer to the exhibit. A network operator is working to filter routes from being advertised that are covered under an aggregate announcement.
The receiving router of the aggregate announcement block is still getting some of the more specific routes plus the aggregate.
Which configuration change ensures that only the aggregate is announced now and in the future if other networks are to be added?
- A. Set each specific route in the AGGRO policy to drop instead of suppress-route
- B. Configure the summary-only keyword on the aggregate command
- C. Filter the routes on the receiving router
- D. Set each specific route in the AGGRO policy to remove instead of suppress-route
Answer: B
NEW QUESTION 24
Compare different features between OSPFv2 and OSPFv3. Drag and drop the descriptions of OSPF from the left onto the correct OSPF versions on the right.
Answer:
Explanation:
NEW QUESTION 25
Refer to the exhibit.
Refer to the exhibit. A network engineer is investigating a report of packet drops between the branch site and the central site.
The two sites are connected via OSPF and RSVP-TE tunnels.
Traffic from the central site to the branch site is passing normally.
Technicians at both sites successfully ping the loopback IP addresses on routers R1 and R2.
Which configuration corrects the packet-drop problem?
- A. Option C
- B. Option D
- C. Option B
- D. Option A
Answer: B
NEW QUESTION 26
Refer to the exhibit.
P1 and PE3 Cisco IOS XR routers are directly connected and have this configuration applied. The BGP session is not coming up. Assume that there is no IP reachability problem and both routers can open tcp port 179 to each other. Which action fixes the issue?
- A. Change HMAC-MD5 to HMAC-SHA1-12
- B. Change HMAC-MD5 to HMAC-SHA1-20
- C. Change HMAC-MD5 to MD5
- D. Configure the send and accept lifetime under key 1
Answer: D
NEW QUESTION 27
Refer to the exhibit. Router 1 is connected to router 2 on interface TenGigE0/1.
Which interface provides the alternate path to 172.16.200.9/32 when the link between router 1 and router 2 goes down?
- A. TenGigE0/2 interface provides the alternate path
- B. A backup path must be statically installed
- C. TenGigE0/1 interface provides the alternate path
- D. A primary path must be manually installed
Answer: A
NEW QUESTION 28
Refer to the exhibit. After troubleshooting an OSPF adjacency issue, routers 1, 2, and 3 have formed OSPF neighbor relationships.
Which statement about the configuration is true?
- A. Router 2 receives a Type 7 LSAs from router 3 for its connected subnets
- B. Router 2 uses router 1 as the next hop for 192.168.0.0/24
- C. Router 2 receives a Type 5 LSAs from router 1 for its connected subnets
- D. Router 2 uses router 3 as the next hop for 192.168.0.0/24
Answer: C
NEW QUESTION 29
Refer to the exhibit.
Traffic flow from router R1 to router R6 is delay-sensitive It must consider potential link-failure and node-failure conditions Which configuration must an engineer apply to router R1 to route traffic to router R6 if router R2 fails?
- A. Option C
- B. Option B
- C. Option D
- D. Option A
Answer: B
NEW QUESTION 30
Refer to the exhibit.
R1 is directly connected to R2 and R3. R1 is in BGP AS 123, R2 is in BGP AS 2, and R3 is in BGP AS 3. Assume that there is no connectivity issue between R1, R2 and R1, R3. Which result between BGP peers R1, R2 and R1, R3 is true?
- A. The BGP session comes up between R1 and R2, but not between R1 and R3.
- B. The BGP session comes up between R1 and R3, but not between R1 and R2.
- C. The BGP session does not come up between R1 and R2 and between R1 and R3.
- D. The BGP session comes up between R1 and R2 and between R1 and R3.
Answer: D
NEW QUESTION 31
Refer to the exhibit.
Routers within the cluster are not receiving the desired prefixes. What must be done to fix the issue?
- A. No client-to-client reflection must be enabled.
- B. Clients in that cluster must have full mesh connectivity between iBGP peers.
- C. No client-to-client must be disabled.
- D. Clients in that cluster must have full mesh connectivity between eBGP peers.
Answer: B
NEW QUESTION 32
Which statement about enabling segment routing for IGPs is true?
- A. Segment routing can be enabled only globally
- B. Segment routing can be enabled only under the routing process
- C. Segment routing must first be enabled under then routing process and then globally
- D. Segment routing must first be enabled globally and then under the routing process
Answer: D
Explanation:
Reference:
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/seg_routing/configuration/xe-16-6/segrt-xe-16-6- book/sr-ospfv2-node-sid.html
NEW QUESTION 33
......
Cisco 300-510 Exam Certification Details:
| Passing Score | Variable (750-850 / 1000 Approx.) |
| Exam Name | Implementing Cisco Service Provider Advanced Routing Solutions |
| Number of Questions | 55-65 |
| Duration | 90 minutes |
| Sample Questions | Cisco 300-510 Sample Questions |
Dumps MoneyBack Guarantee - 300-510 Dumps Approved Dumps: https://pass4lead.premiumvcedump.com/Cisco/valid-300-510-premium-vce-exam-dumps.html